This procedure can address any deep scratches on the wood floors. After the hardwood is completely sanded a rotary screening is completed to ensure a smooth surface. The floor is then vacuumed, and tacked passed over with a dampened towel to remove any dust, prior to stain or finishing polyurethane being applied.
Typical three coatings of polyurethane are applied to the wood floors during the refinishing process. Customers choose from a satin, semi-gloss or gloss finish. The maintenance coating procedure can help prolong the length of time between a full sanding or refinishing of your wood floors. Over time, the top protective layer of finish will wear down. This in turn leaves the wood more vulnerable to scratches and floors can dull.
The key is to have your floors buffed and re-coated before they get deep scratches or too worn. Adding shine to your hardwood floors prior to listing with a broker will give a great first impression to potential buyers when they enter your home. The added life and luster of your floors is sure to increase your homes appeal and may speed up the sale. How often your hardwood floors need a maintenance coating depends on foot traffic.
A simple screen and recoat will not remove these scratches. If they are shallow enough, a refinishing job should take care of them. However, if they are too deep, the only way to solve them is to replace the boards in question, or even the entire floor if they are present in several boards.
Water stains are present. Ripping up and replacing the floors is usually your last resort. But sometimes you just have to do it. Here are some tips:. This blog is quite informative regarding importance of maintenance of hardwood floors and its refinishing.. Thank you!! This blog is really enlightening of the fact that it has helped me a lot to figure out the required service to be given to the hardwood flooring in my office building at the most appropriate time…Thank you for providing this information!!
Empty the room, removing as much furniture as possible, then clean the floor thoroughly to remove dust and dirt. Sweep or vacuum, then mop with a commercial wood floor cleaner or solution of a quarter-cup of dish soap and a gallon of warm water to lift any lingering grime. Give the floors a final pass with a clean, water-dampened mop to remove any cleaner residue. Dry completely with a soft, clean towel.
Begin in a back corner of the room, plotting a path that will have you end up near an exit, pour a small S-shaped amount of wood floor polish onto the floor. Using a flat-surface mop, work the solution back and forth in the direction of the wood grain, smoothing out any air bubbles. While you must make sure to completely coat the floor, thin layers will dry more rapidly than thick ones, and you can always apply another coat if needed.
Wait at least one hour before allowing light traffic through the room and a full day before moving your belongings back in and resuming normal use. To avoid scratching, take care not to drag or slide furniture; pick up each piece up and place them where they belong.
Attach felt furniture pads underneath heavy pieces for extra protection. Now that your floors look like new, maintain them by placing rugs at entry doors to prevent dirt from being tracked inside.
0コメント